Back

CARBURETOR STRAPS

Model CARS KEV

Material Color ARAMID strap + Kevlar thread

ARAMID Carburetor safety strap for racing drag bikes
Blow-back carb safety (hold-on) straps for drag-bikes
One size fits all
ARAMID fire-resistant webbing
Brass hardware

SPECIAL ORDER ITEM OF DOMESTIC AND/OR IMPORTED MATERIALS

$119.00

Size

Material Color

Quantity

WARNING:---This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. ---- ADVERTENCIA: Este producto puede exponerlo a productos quimicos y materiales que el estado de California reconoce como causantes de cancer y defectos de nacimiento u otros danos reproductivos. ---- For more information: www.P65Warnings.ca.gov
Vansons Motorcycle Armor Disclaimer.... Motorcycle Sports are inherently dangerous and involve the risk of serious injury or death. Riders using these products ride at their own risk with full knowledge of the hazards and risks associated with their activities. Armor cannot offer complete protection from injury or death to riders. Motorcycle Armor cannot protect areas of the body that are not covered and offer no protection against injuries involving forces other than impact. CAUTION: Body Armor Protectors (Vanson GP F.A.S. Armor and CE approved Armor) must fit properly and be securely fastened. Armor components that are damaged should be destroyed and replaced. The protective properties of the Armor may be compromised by prior impact - age - use and other substances. Always follow the manufacturers recommendations before applying cleaning agents - paints - or adhesives. Vanson Leathers disclaims any responsibility for injuries or death incurred while wearing any of the Armor offered for sale. Representations regarding testing results - equipment ratings - product specifications - ASTM and/or SEI standards - and the adequecy of all such standards and designations are made solely by the products manufacturer. Vanson Leathers makes no representations express or implied regarding the fitness of these products for any particular purpose nor the extent to which the products protect riders from injury or death.

Carburetor Straps

Kevlar®? Webbing is one of the lightest and strongest webbings available. It has a 2000 pound pound breaking strength and weighs just 3.3 grams per foot.

It has almost no stretch and doesn’t absorb much water. This makes it ideal for anti-blast straps to hold carbs onto a backfiring dragbike. This webbing is extremely resistant to friction and heat and only starts to decompose at 800 degrees Fahrenheit.

Kevlar® thread is used to provide maximum strength in every area of these safety straps.

Kevlar® is effected by UV light and after 450 hours of direct sunlight it can turn brown and lose up to 50% of its breaking strength. This is important to note and this product is not ideal to be used on a permanent outdoor basis that would be receiving a lot of UV exposure from sunlight. Made in the USA

DuPontTM and Kevlar® are trademarks or registered trademarks of E.I. du Pont de Nemours and Company.

Set of 3 straps = designed to hold the carburator on intake manifold in the
event of a BACKFIRE. Used for Drag Racing.
2 straps have D-Ring pairs for holding the center-strap to frame/manifold.
Center strap is meant to capture the carburetor set. D-Ring sets on the
frame loop short straps allow for adjustability.

Ballistic ARAMID is used for all 3 straps.
Matching ARAMID thread is used in all stitching.
ARAMID resists flame and has tremendous tensile strength.
Solid polished-brass D-Rings are used for adjustability.

CARBURETOR STRAPS

Carburetor Straps

Kevlar®? Webbing is one of the lightest and strongest webbings available. It has a 2000 pound pound breaking strength and weighs just 3.3 grams per foot.

DuPontTM and Kevlar® are trademarks or registered trademarks of E.I. du Pont de Nemours and Company.

Viewed Products